AW-Lake CAPM-2 Carrier Frequency Sensor is a Carrier Frequency sensor, which means there is no permanent magnet in the pickup, and any magnetic drag on the flow meter is avoided. The CAPM-2 requires a supply voltage between 10 VDC and 30 VDC.
 |
| AW-Lake CAPM-2 Carrier Frequency Sensor |
A diode in the supply input prevents damage to the module in case the polarity of the supply voltage is wrong. The output signal is a square wave, voltage pulse of approximate amplitude (supply – 1.5 V). The frequency is proportional to the flow rate. For use with JV-CG and JV-KG meters (not for use with aluminum meters).
AW-Lake CAPM-2 Carrier Frequency Sensor Features:
- Meter Compatibility: Used with JV-CG and JV-KG meters (not for use with aluminum meters)
- Output Signal: Square wave, voltage pulse of approximate aplitude (supply - 1.5V)
- Sourcing Output: PNP type sourcing open collector transistor
- Intrinsically Safe: Intrinsically safe CAPM-2o version available
- IS Safe Version: UL & cUL certified for use in Class 1, Div 1 locations
Installation:
- Ensure that the flow meter sensor cavity is free of debris prior to installation.
- Screw the CAPM-2 into the flow meter by hand until the sensor nose contacts the bottom of the cavity.
- Do not screw in harder than hand tight, as a thin metal section is under the sensor nose
Specification:
- Supply Voltage: 10 to 30 VDC
- Supply Current: 9 mA @ 15 Volt, Max 18 mA
- Minimum Signal: 0.5 Hz
- Signal Output:
- Square wave
- VHigh ≈ VCC - 1.5V
- VLow ≈ 0V
- Duty Cycle: 50%
- Frequency Output: Flow dependent up to 2000 Hz
- Load: >500Ω
- Driving Capacity: 10 mA Max
- Temperature Range: -60°F to 185°F (-50°C to 85°C)
Download Data Sheet: CAPM-2 Carrier Frequency Sensor
Ref: aw-lake.com
Hello, my name is Jack Sparrow. I'm a 50 year old self-employed Pirate from the Caribbean. 
